<aside> ℹ️ To use this menu, you must have the latest version of the gamepad's firmware installed.

</aside>

You can set power-save sleeping time, LED brightness, calibration stick & trigger keys, and naming of gamepad

• Sleeping time: 30 min is the default value, can adjust it to 5,10, 60 min.

• LED Brightness: Adjust 15 steps, but no allow to switch off completely

• Calibration of a stick, trigger

  

Calibration for Sticks (L-Stick, R-Stick)

When you using a gamepad sometimes or heavily, the position of the analog stick or trigger could be non-centered. In such a case, this calibration app can adjust the position accordingly again to be centered.

1. Select stick icon (LS/RS)

2. Draw stick and release it, move it to the center point

   

3. Calculating center value, waiting until complete.

   

4. Move the stick to each direction and wait until completed. Up→ down→ left→ right direction by turn.

   

5. All steps end, check its position point

   

   

   <aside> 📢 If you press CANCEL, the calibration process will be canceled.

   </aside>

Calibration of trigger (LT/RT, a.k.a. L2/R2)

If the trigger value is not O when it is idle status without moving, or if it is not reaching the max value when the triggered is fully pulled.

1. Start trigger calibration (LT/RT)

2. Pull it maximum and release slowly

   

3. Calculating center value, waiting until complete.

   

4. According to pop-up, push trigger, and wait the progress bar moves.

   

5. After calibration complete, check its function and save to exit

   

   

   <aside> 📢 If you press CANCEL, the calibration process will be canceled.

   </aside>